Low-Cost Online Monitoring System for the Etching Process in Fiber Optic Sensors by Computer Vision.

The present research exposes a novel methodology to manufacture fiber optic sensors following the etching process by Hydrofluoric Acid deposition through a real-time monitoring diameter measurement by computer vision. This is based on virtual instrumentation developed with the National Instruments® technology and a conventional digital microscope. Here, the system has been tested proving its feasibility by the SMS structure diameter reduction from its original diameter of 125 µ until approximately 42.5 µm. The results obtained have allowed us to demonstrate a stable state behavior of the developed system during the etching process through diameter measurement at three different structure sections. Therefore, this proposal will contribute to the etched fiber optic sensor development that requires reaching an enhanced sensitivity. Finally, to demonstrate the previously mentioned SMS without chemical corrosion, and the etched manufactured SMS, both have been applied as glucose concentration sensors.

Onboard early detection and mitigation of lithium plating in fast-charging batteries.

Fast-charging is considered as one of the most desired features needed for lithium-ion batteries to accelerate the mainstream adoption of electric vehicles. However, current battery charging protocols mainly consist of conservative rate steps to avoid potential hazardous lithium plating and its associated parasitic reactions. A highly sensitive onboard detection method could enable battery fast-charging without reaching the lithium plating regime. Here, we demonstrate a novel differential pressure sensing method to precisely detect the lithium plating event. By measuring the real-time change of cell pressure per unit of charge (dP/dQ) and comparing it with the threshold defined by the maximum of dP/dQ during lithium-ion intercalation into the negative electrode, the onset of lithium plating before its extensive growth can be detected with high precision. In addition, we show that by integrating this differential pressure sensing into the battery management system (BMS), a dynamic self-regulated charging protocol can be realized to effectively extinguish the lithium plating triggered by low temperature (0 °C) while the conventional static charging protocol leads to catastrophic lithium plating at the same condition. We propose that differential pressure sensing could serve as an early nondestructive diagnosis method to guide the development of fast-charging battery technologies.

Design and On-Field Validation of an Embedded System for Monitoring Second-Life Electric Vehicle Lithium-Ion Batteries.

In the last few years, the growing demand for electric vehicles (EVs) in the transportation sector has contributed to the increased use of electric rechargeable batteries. At present, lithium-ion (Li-ion) batteries are the most commonly used in electric vehicles. Although once their storage capacity has dropped to below 80-70% it is no longer possible to use these batteries in EVs, it is feasible to use them in second-life applications as stationary energy storage systems. The purpose of this study is to present an embedded system that allows a Nissan® LEAF Li-ion battery to communicate with an Ingecon® Sun Storage 1Play inverter, for control and monitoring purposes. The prototype was developed using an Arduino® microcontroller and a graphical user interface (GUI) on LabVIEW®. The experimental tests have allowed us to determine the feasibility of using Li-ion battery packs (BPs) coming from the automotive sector with an inverter with no need for a prior disassembly and rebuilding process. Furthermore, this research presents a programming and hardware methodology for the development of the embedded systems focused on second-life electric vehicle Li-ion batteries. One second-life battery pack coming from a Nissan® Leaf and aged under real driving conditions was integrated into a residential microgrid serving as an energy storage system (ESS).

Paramagnetic encoding of molecules.

Contactless digital tags are increasingly penetrating into many areas of human activities. Digitalization of our environment requires an ever growing number of objects to be identified and tracked with machine-readable labels. Molecules offer immense potential to serve for this purpose, but our ability to write, read, and communicate molecular code with current technology remains limited. Here we show that magnetic patterns can be synthetically encoded into stable molecular scaffolds with paramagnetic lanthanide ions to write digital code into molecules and their mixtures. Owing to the directional character of magnetic susceptibility tensors, each sequence of lanthanides built into one molecule produces a unique magnetic outcome. Multiplexing of the encoded molecules provides a high number of codes that grows double-exponentially with the number of available paramagnetic ions. The codes are readable by nuclear magnetic resonance in the radiofrequency (RF) spectrum, analogously to the macroscopic technology of RF identification. A prototype molecular system capable of 16-bit (65,535 codes) encoding is presented. Future optimized systems can conceivably provide 64-bit (~10^19 codes) or higher encoding to cover the labelling needs in drug discovery, anti-counterfeiting and other areas.

An Indoor Navigation Methodology for Mobile Devices by Integrating Augmented Reality and Semantic Web.

Indoor navigation systems incorporating augmented reality allow users to locate places within buildings and acquire more knowledge about their environment. However, although diverse works have been introduced with varied technologies, infrastructure, and functionalities, a standardization of the procedures for elaborating these systems has not been reached. Moreover, while systems usually handle contextual information of places in proprietary formats, a platform-independent model is desirable, which would encourage its access, updating, and management. This paper proposes a methodology for developing indoor navigation systems based on the integration of Augmented Reality and Semantic Web technologies to present navigation instructions and contextual information about the environment. It comprises four modules to define a spatial model, data management (supported by an ontology), positioning and navigation, and content visualization. A mobile application system was developed for testing the proposal in academic environments, modeling the structure, routes, and places of two buildings from independent institutions. The experiments cover distinct navigation tasks by participants in both scenarios, recording data such as navigation time, position tracking, system functionality, feedback (answering a survey), and a navigation comparison when the system is not used. The results demonstrate the system's feasibility, where the participants show a positive interest in its functionalities.

Cross-Bridged Cyclam with Phosphonate and Phosphinate Pendant Arms: Chelators for Copper Radioisotopes with Fast Complexation.

Cross-bridged cyclam derivatives bearing two phosphonate (H4L1), bis(phosphinate) (H4L2), or phosphinate (H2L3) pendant arms were synthesized and studied with respect to their application as copper radioisotope carriers in nuclear medicine. The ligands show high macrocycle basicity (pK1 > 14) and high Cu(II) complex stability (log K = 20-24). The complexation and dissociation kinetics of the Cu(II) complexes were studied by ultraviolet-visible spectroscopy. Phosphonate Cu(II)-H4L1 and bis(phosphinate) Cu(II)-H4L2 complexes form very quickly, reaching quantitative formation within 1 s at pH ∼6 and millimolar concentrations. Conversely, the formation of the phosphinate complex Cu(II)-H2L3 is much slower (9 min at pH ∼6) due to the low stability of the out-of-cage reaction intermediate. All studied complexes are highly kinetically inert, showing half-lives of 120, 11, and 111 h for Cu(II)-H4L1, Cu(II)-H4L2, and Cu(II)-H2L3 complexes, respectively, in 1 M HClO4 at 90 °C. The high thermodynamic stability, fast formation, and extreme kinetic inertness of Cu(II) complexes indicate that phosphonate and bis(phosphinate) derivatives are promising ligands for nuclear medicine.

Low-dimensional compounds containing bioactive ligands. Part XIV: High selective antiproliferative activity of tris(5-chloro-8-quinolinolato)gallium(III) complex against human cancer cell lines.

Four gallium(III) complexes, [Ga(ClQ)3]⋅MeOH (1 - MeOH), [Ga(ClQ)3] (1), [Ga(BrQ)3] (2), [Ga(dIQ)3] (3) and [Ga(CQ)3] (4), were prepared (H-ClQ = 5-chloro-8-quinolinol, H-BrQ = 7-bromo-8-quinolinol, H-dIQ = 5,7-diiodo-8-quinolinol, H-CQ = 5-chloro-7-iodo-8-quinolinol) and characterised by elemental analysis, IR and NMR spectroscopy. Single crystal structure analysis of 1 - MeOH confirmed that the complex has a molecular structure with gallium(III) metal ion coordinated in mer-fashion by N- and O-donor atoms of three ClQ ligands. Stability of all complexes in DMSO was proved by 1H NMR spectroscopy. The in vitro antiproliferative activity of 1 was evaluated against the A2780, MBA-MB-231 and HCT116 cell lines. Complex 1 displays higher antiproliferative activity (IC50 values in the range 2.1-6 µm) compared to the ClQ ligand and cisplatin; and a significant selective antiproliferative potency (IC50 = 136 µm, for normal MRC5pd30 cell line). Radical scavenging experiments revealed that complex 1 exhibits the highest antioxidant activity of the prepared complexes as well as the ligands.

Improved Conjugation, 64-Cu Radiolabeling, in Vivo Stability, and Imaging Using Nonprotected Bifunctional Macrocyclic Ligands: Bis(Phosphinate) Cyclam (BPC) Chelators.

Bifunctional derivatives of bis(phosphinate)-bearing cyclam (BPC) chelators bearing a carboxylate, amine, isothiocyanate, azide, or cyclooctyne in the BP side chain were synthesized. Conjugations required no protection of phosphinate or ring secondary amine groups. The ring amines were not reactive (proton protected) at pH < ∼8. For isothiocyanate coupling, oligopeptide N-terminal α-amines were more suitable than alkyl amines, e.g., Lys ω-amine (p Ka ∼7.5-8.5 and ∼10-11, respectively) due to lower basicity. The Cu-64 labeling was efficient at room temperature (specific activity ∼100 GBq/µmol; 25 °C, pH 6.2, ∼100 ligand equiv, 10 min). A representative Cu-64-BPC was tested in vivo showing fast clearance and no nonspecific radioactivity deposition. The monoclonal anti-PSCA antibody 7F5 conjugates with thiocyanate BPC derivative or NODAGA were radiolabeled and studied in PC3-PSCA tumor bearing mice by PET. The radiolabeled BPC conjugate was accumulated in the prostate tumor with a low off-target uptake, unlike Cu-64-labeled NODAGA-antibody conjugate. The BPC chelators have a great potential for theranostic applications of the Cu-64/Cu-67 matched pair.

Cyclam Derivatives with a Bis(phosphinate) or a Phosphinato-Phosphonate Pendant Arm: Ligands for Fast and Efficient Copper(II) Complexation for Nuclear Medical Applications.

Cyclam derivatives bearing one geminal bis(phosphinic acid), -CH2PO2HCH2PO2H2 (H2L(1)), or phosphinic-phosphonic acid, -CH2PO2HCH2PO3H2 (H3L(2)), pendant arm were synthesized and studied as potential copper(II) chelators for nuclear medical applications. The ligands showed good selectivity for copper(II) over zinc(II) and nickel(II) ions (log KCuL = 25.8 and 27.7 for H2L(1) and H3L(2), respectively). Kinetic study revealed an unusual three-step complex formation mechanism. The initial equilibrium step leads to out-of-cage complexes with Cu(2+) bound by the phosphorus-containing pendant arm. These species quickly rearrange to an in-cage complex with cyclam conformation II, which isomerizes to another in-cage complex with cyclam conformation I. The first in-cage complex is quantitatively formed in seconds (pH ≈5, 25 °C, Cu:L = 1:1, cM ≈ 1 mM). At pH >12, I isomers undergo nitrogen atom inversion, leading to III isomers; the structure of the III-[Cu(HL(2))] complex in the solid state was confirmed by X-ray diffraction analysis. In an alkaline solution, interconversion of the I and III isomers is mutual, leading to the same equilibrium isomeric mixture; such behavior has been observed here for the first time for copper(II) complexes of cyclam derivatives. Quantum-chemical calculations showed small energetic differences between the isomeric complexes of H3L(2) compared with analogous data for isomeric complexes of cyclam derivatives with one or two methylphosphonic acid pendant arm(s). Acid-assisted dissociation proved the kinetic inertness of the complexes. Preliminary radiolabeling of H2L(1) and H3L(2) with (64)Cu was fast and efficient, even at room temperature, giving specific activities of around 70 GBq of (64)Cu per 1 µmol of the ligand (pH 6.2, 10 min, ca. 90 equiv of the ligand). These specific activities were much higher than those of H3nota and H4dota complexes prepared under identical conditions. The rare combination of simple ligand synthesis, very fast copper(II) complex formation, high thermodynamic stability, kinetic inertness, efficient radiolabeling, and expected low bone tissue affinity makes such ligands suitably predisposed to serve as chelators of copper radioisotopes in nuclear medicine.

Methylene-bis[(aminomethyl)phosphinic acids]: synthesis, acid-base and coordination properties.

Three symmetrical methylene-bis[(aminomethyl)phosphinic acids] bearing different substituents on the central carbon atom, (NH(2)CH(2))PO(2)H-C(R(1))(R(2))-PO(2)H(CH(2)NH(2)) where R(1) = OH, R(2) = Me (H(2)L(1)), R(1) = OH, R(2) = Ph (H(2)L(2)) and R(1),R(2) = H (H(2)L(3)), were synthesized. Acid-base and complexing properties of the ligands were studied in solution as well as in the solid state. The ligands show unusually high basicity of the nitrogen atoms (log K(1) = 9.5-10, log K(2) = 8.5-9) if compared with simple (aminomethyl)phosphinic acids and, consequently, high stability constants of the complexes with studied divalent metal ions. The study showed the important role of the hydroxo group attached to the central carbon atom of the geminal bis(phosphinate) moiety. Deprotonation of the hydroxo group yields the alcoholate anion which tends to play the role of a bridging ligand and induces formation of polynuclear complexes. Solid-state structures of complexes [H(2)N=C(NH(2))(2)][Cu(2)(H(-1)L(2))(2)]CO(3)·10H(2)O and Li(2)[Co(4)(H(-1)L(1))(3)(OH)]·17.5H(2)O were determined by X-ray diffraction. The complexes show unexpected geometries forming dinuclear and cubane-like structures, respectively. The dinuclear copper(II) complex contains a bridging µ(2)-alcoholate group with the (-)O-P(=O)-CH(2)-NH(2) fragments of each ligand molecule chelated to the different central ion. In the cubane cobalt(II) complex, one µ(3)-hydroxide and three µ(3)-alcoholate anions are located in the cube vertices and both phosphinate groups of one ligand molecule are chelating the same cobalt(II) ion while each of its amino groups are bound to different neighbouring metal ions. All such three metal ions are bridged by the alcoholate group of a given ligand.